Mastervolt EasyView 5 User Manual

24
EasyView 5 - User’s and Installation Manual
Event X
Command
Event-based command
Action to be taken by the Event X target.
Choose…
System dependent
Event X Data
Event 1 data controls the Event X command,
see section 6.8 for explanation.
Off
Off, On, Copy, Copy
Invert, Toggle
6.7.2 Event target
The EasyView 5 can be configured as an event target by other devices on the MasterBus network.
When the display is configured as an event target by another device, this device can initiate an
event command and an event action to be performed by the EasyView 5.
An example might be that the buzzer of the EasyView 5 is switched on when there is a battery pre-
low warning by a MLi battery. The event source is battery pre-low, the event target is the EasyView
5, the event command is Buzzer and event data Copy.
Item
Meaning
Default
Range
Event X
Source
Choose an event to serve as Event X
Disabled means no event has been
configured.
Choose…
System dependent
Event X
Target
Selection of the MasterBus connected device
to take action due to Event X
Choose…
System dependent
Event X
Command
Event-based command
Action to be taken by the Event X target.
Disabled
Disabled,
Feedback 1-6,
Lock,
State,
Buzzer,
Event X Data
Event 1 data controls the Event X command,
see section 6.8 for explanation.
Off
Off, On, Copy, Copy
Invert, Toggle

Mastervolt EasyView 5 Specifications

General

Brand	Mastervolt
Model	EasyView 5
Category	Control Panel
Language	English