Mastervolt EasyView 5 User Manual

8
EasyView 5 - User’s and Installation Manual
2 Safety
2.1 Safety instructions
WARNING!
Read the safety instructions before connecting and using the EasyView 5.
• Use the EasyView 5 following the instructions and specifications stated in this manual.
• Only use the EasyView 5 in a technical correct condition.
• Do not connect the EasyView 5 to any other network than the MasterBus network.
• Do not work on an electrical system if it is still connected to a current source. Only allow
changes in your electrical system to be carried out by qualified electricians.
2.2 Liability
Mastervolt cannot be held liable for:
• Consequential damage resulting from the use of the EasyView 5.
• Possible errors in the included manual and the consequences of these.
• Inappropriate usage that is inconsistent with the purpose of the product.
2.3 Warranty
Mastervolt assures a two year warranty on the EasyView 5 after purchase, on the condition that the
product is installed and used according to the instructions in this manual.
Installation or use not according to these instructions may result in under performance, damage or
failure of the product and may void this warranty. The warranty is limited to the cost of repair and/or
replacement of the product. Costs for labour or shipping are not covered by this warranty.
2.4 Correct disposal of this product
(Waste Electrical & Electronic Equipment)
This product is designed and manufactured with high quality materials and
components, which can be recycled and reused. When this crossed-out wheeled bin
symbol is attached to a product, it means the product is covered by the European
Directive 2012/19/EU.
Please be informed about the local separate collection system for electrical and electronic products.
Please act according to your local rules and do not dispose of your old products with your normal
household waste. The correct disposal of your old product will help prevent potential negative
consequences to the environment and human health.
2.5 Identification label
The identification label (see figure 1) is
located at the back side of the EasyView
5. Important technical information
required for service and maintenance can
be derived from the identification label.
Never remove the identification label!
Warranty void when label is removed!
Figure 1: Identification label

Mastervolt EasyView 5 Specifications

General

Brand	Mastervolt
Model	EasyView 5
Category	Control Panel
Language	English