Mastervolt MLI Ultra - Page 20

20
MLI Ultra 12/1250, 24/1250 – User and Installation Manual
18. From the Control Input drop-down list, select Stop Charge.
19. Click OK.
Return to step 16 until all MLI Ultra units have this switch configured.
20. Click the Add button in the Circuit Loads panel.
21. From the Load drop-down list, select the required charger.
22. Set the State to Off.
23. Click the Timer/Advanced Settings button.
24. 'Stop Charge' circuit switch only: from the Control Type drop-down list, select Set Limit and click
OK.
25. Click OK to close the Circuit Load Configuration window.
Optionally, return to step 20 to do this for all chargers.
26. Return to step 14 to configure more circuits.
27. Write the configuration to the network to use the new configuration.