This model is further referred to as “Solar ChargeMaster”.
All the specifications, provisions and instructions contained
in this manual apply solely to standard versions of the Solar
ChargeMaster delivered by Mastervolt.
2.2 LIABILITY
Mastervolt can accept no liability for:
• Consequential damage resulting from the use of the
Solar ChargeMaster.
• Possible errors in the included manual and the
consequences of these.
• Use that is inconsistent with the purpose of the product.
2.3 WARRANTY
The Mastervolt product warranty covers the Solar
ChargeMaster for the first two years after the purchase
date, on the condition that the product is installed and used
according to the instructions in this manual.
Installation or use that do not comply with these instructions
may result in under performance, damage or failure of the
product and may void this warranty. The warranty is limited
to the cost of repair and/or replacement of the product.
Costs of labor or shipping are not covered by this warranty.
2.4 DISCLAIMER
Our products are subject to continual development and
improvement. Therefore, additions or modifications to the
products may cause changes to the technical data and
functional specifications. No rights can be derived from this
document. Please consult our most current Terms &
Conditions of Sale.
2.5 CORRECT DISPOSAL OF THIS PRODUCT
This product is designed and manufactured
with high quality materials and components,
which can be recycled and reused. Dispose of
according to WEEE.
Act according to your local rules and do not dispose of your
old products with your normal household waste. The correct
disposal of your old product will help prevent potential
negative consequences to the environment and human
health.
2.6 USE OF PICTOGRAMS
Safety instructions and warnings are marked in this manual
and on the product by the following pictograms:
2.7 IDENTIFICATION LABEL
Figure 2: Identification label
The identification label is located at the right-hand side of
the Solar ChargeMaster (see Figure 1). Important technical
information required for service, maintenance & secondary
delivery of parts can be derived from the identification label.
To Next Page
Loading...
