38 PROTON 206/308 V1 System Manual
Following points are relevant:
• Maximum 10 feature groups can be formed (0-9).
• Each feature can be enabled or disabled in each group.
• Group 2 is the default COS group.
How to program?
Step 1: Decide the number of COS groups to be used.
Step 2: Prepare a list of the features required in each COS group and program it using command 250.
Step 3: Assign COS group to a station during daytime/nighttime using command 31.
Step 1
Take a pen and a paper and decide the number of groups to be formed and what all features are to be enabled
in each group.
Step 2
Use following command to enable/disable a feature in a COS group:
250-COS Group-Feature Index-Code
Where,
COS Group is from 0 to 9.
Feature Index is from 00 to 15.
Step 3
Use following command to assign a COS group to station during daytime/nighttime:
31-Station-COS Group for Daytime-COS Group for Nighttime
Where,
Station is from 21 to 28.
COS Group for Daytime is from 0 to 9.
COS Group for Nighttime is from 0 to 9.
Use following command to assign a same COS group to all stations during daytime/nighttime:
31-*-COS Group for Daytime-COS Group for Nighttime
Where,
COS Group for Daytime is from 0 to 9.
COS Group for Nighttime is from 0 to 9.
Example:
Make a COS group ‘5’ having features like Call Transfer, Conference, Hot Outward Dialing, Call Forward, Auto
Call Back, Raid, Trunk Reservation.
250-5-02-1
250-5-03-1
250-5-05-1
250-5-08-1
250-5-10-1
250-5-12-1
250-5-13-1
Relevant Topic:
1. “Day and Night Modes” 40
Code Meaning
0 Feature Disabled
1 Feature Enabled
To Next Page
Loading...
