30 PROTON 206/308 V1 System Manual
Step 3
Please refer “Class Of Service (COS)” for details on how to allow Call Pick-Up feature to the user.
Important Point:
• Alarm ring and Auto Call Back ring cannot be picked up from any other station.
Relevant Topic:
1. “Class Of Service (COS)” 36
Call Progress Tones
The PROTON 206/308 gives various tones in different situations. This is how the PROTON 206/308 responds to
dialing of codes and commands.
Dial Tone
When you lift the handset you get dial tone. Dial tone stays for 7 seconds. This Dial Tone Timer is
programmable. After that error tone starts.
• Sound: Toooooooooooo
Use following command to program the Dial Tone Timer:
217-00-Seconds
Range = 01 to 99 seconds
Default = 07 seconds
Ring Back Tone
When you dial internal number and if that number is free, you will get the ring back tone. The ring back tone
continues for 45 seconds. This Ring Back Tone Timer is programmable.
• Sound: Turroo... Turrroo
Use following command to program the Ring Back Tone Timer:
217-01-Seconds
Range = 01 to 99 seconds
Default = 45 seconds
Busy Tone (Engage Tone)
High pitch beeps with equal on and off periods. When you dial any station that is busy, you get busy tone. Busy
tone continues for 5 seconds. This timer is programmable.
• Sound: Tooooooo.........Toooooooo
Use following command to program the Busy Tone timer:
217-02-Seconds
Range = 01 to 99 seconds
Default = 05 seconds
Error Tone
The Error Tone is made of fast beeps. When you perform some wrong operation or try using a feature without
access, you get error tone.
• Sound: Too…Too…Too…Too
To Next Page
Loading...
