58 PROTON 206/308 V1 System Manual
Station is from 21 to 28.
Use following command to assign same group number to all the stations:
38-*-Group Number
By default, all stations are in Universal Group.
Example:
Program the system for following conditions:
• Two groups (station 21, 22 and 23 in group1 and station 24 and 25 in group 2) and a solo group (station 26)
have to be programmed. Station 27 and 28 are in universal group.
Use following commands to accomplish the requirement:
38-21-1
38-22-1
38-23-1
38-24-2
38-25-2
38-26-0
38-27-9
38-28-9
• Doing so, station 21, 22 and 23 can talk to each other as well as to station 27 and 28 but cannot talk to station
24, 25 and 26.
• Station 24 and 25 can talk to each other as well as to station 27 and 28, but cannot talk to station 21, 22 and
23.
• Station 26 can talk to station 27 and 28 only.
• Station 27 and 28 can talk to each other as well as to any other station.
Interrupt Request
What’s this?
• When your call is urgent and you cannot wait for the called person to become free, you can land in his
conversation after intimating him.
• While landing, you get ring back tone and the called person gets beeps for 45 seconds.
• During the beeps, the called person can dial ‘Flash-1’ to answer your call. He can talk to you while his
previous partner is put on hold and gets music.
• Replace your handset once your talk is over. This will automatically restore his original speech with the held-
up party.
How to use it?
How to program?
Please refer “Class Of Service (COS)” for details on how to allow Interrupt Request to a user.
Group Number Description
0 Solo Group
1 to 8 Party Group
9 Universal Group
1 Lift handset. Dial tone
2 Dial Number. Busy tone
3 Dial 3. Music. The destination gets beep.
4 Start talking when the called station
includes you by dialing Flash-1.
Speech.
To Next Page
Loading...
