48 PROTON 206/308 V1 System Manual
To Change user password
• In case you forget your password, do not panic. Contact the System Administrator (SA) or the System
Engineer (SE). He can clear your password to its default value. Refer “System Security (Passwords)” for
more details.
To set Lock Level
By default, Allowed/Denied List Level ‘0’ is assigned in locked state.
How to program?
Dynamic lock is a programmable feature. Please refer “Class Of Service (COS)” for details on how to allow
Dynamic Lock to a user.
Step 1
Decide whether you want to use Manual or Auto Dynamic lock.
Step 2
If you decide to use Manual Dynamic Lock set the parameter ‘minutes’ in the command 143-User Password-
Minutes to 00.
Use command 140 and 141-User Password to lock the station and unlock the station.
Step 3
If you decide to use Auto Dynamic Lock, set the parameter ‘minutes’ in the command 143-User password-
minutes to a desirable value. Use the command ‘141-User Password’ to unlock the station.
Step 4
Change your user password to avoid misuse of your station.
Step 5
Use following command to default dynamic lock settings:
342-Station
Where,
Station is from 21 to 28.
On issuing above command, the dynamic lock will set to manual mode and lock level will set to level ‘0’.
Relevant Topics:
1. “Toll Control” 73
2. “User Security (User Password)” 81
External Call
How to make External Call?
• Lift the handset.
• Dial ‘0’ or ‘5’.
• Dial the External Telephone Number.
1 Lift the handset. Dial tone
2Dial 144-Old User Password-New User Password. Confirmation tone
1 Lift handset. Dial tone
2 Dial 142-User Password-Allowed/Denied List Level. Confirmation tone
3 Replace handset.
To Next Page
Loading...
