68 PROTON 206/308 V1 System Manual
164-23-1-05
To Cancel Alarms
How to program?
Please refer “Class Of Service (COS)” for details or how to allow alarm to a station user.
Important Points:
• For timers of relevance, please refer “Alarm”
• Remote Alarm is allowed to a station that has access to Alarm.
Relevant Topic:
1. “Alarm” 14
Remote Lock
What’s this?
• The SE/SA can lock/unlock a station for outgoing calls remotely.
• The SE/SA can lock/unlock a station for all outgoing calls/selective outgoing calls from any station without
changing the Toll Control of a station.
How to use it?
To Unlock a station remotely:
Use following command to unlock a station (command should be issued from SA/SE mode):
3*1-Station-1
Where,
Station is from 21 to 28.
Or
3*3-Station-1
Where,
Station is from 21 to 28.
On issuing either of the above commands, the station shall allow outgoing calls as per Toll Control programmed
for the station.
To Lock a station remotely:
Use following command to lock a station remotely (command should be issued from SA/SE mode):
3*1-Station-0
Where,
Station is from 21 to 28.
Or
3*3-Station-0
Where,
Station is from 21 to 28.
On issuing either of the above commands the station allows outgoing calls as per the Toll Control programmed
for the locked condition of the station. It also cancels any private trunk set for the station.
1 Lift the handset. Dial tone
2 Dial 160. Confirmation tone
3 Replace the handset.
To Next Page
Loading...
