PROTON 206/308 V1 System Manual 71
• Please note that the system engineer cannot know SA password or user password. However, he can clear
these passwords to their default values.
How to program?
Use following command to change SE Password:
291-New SE Password
New SE password is a number string of 4-digits.
By default, SE password is 1234.
Forgot your program password?
It is very important to remember the SE password. Without this password, it is not possible to enter the program
mode and change the settings. It is advisable to make a note of this password at a safe place.
However, if the system engineer (SE) password is lost, then it can be set to its default value. Following steps
describe the procedure:
• Switch ‘OFF’ the system.
• Wait for 10 seconds.
• Open the system.
• Locate a mini-jumper on the PCB.
• Change position of the jumper.
• Wait for 5 seconds.
• Restore the jumper to its original position.
• Close the system.
• Switch ‘ON’ the system.
Now, the system is ready with default settings. The programming password becomes 1234. Use this password
to enter the programming mode and reprogram the complete system.
System Administrator Password
• The system administrator uses this password.
• SA Password is a 4-digit password. It cannot have either less than or more than 4 digits. Digits 0-9 are valid.
How to program?
Use following command to change SA Password:
292-New SA Password
New SA password is a number string of 4-digits.
By default, SA password is 1111.
User Password (User Security)
The User can secure his station from unauthorized use by way of using User Password. For operational details
on this topic, please refer “User Security (User Password)”.
Relevant Topic:
1. “Programming the System” 64
To Next Page
Loading...
