Matrix ETERNITY Quick Start 69
VoIP Port
Configuring the VoIP (WAN) Port
• The VoIP Card may be installed typically, in a Public IP Network or in a Private
network, behind a NAT Router.
• Depending on your installation scenario, configure the VoIP Port Parameters.
• Click ‘VoIP Configuration’; open ‘VoIP Port Parameters’.
• Ask your LAN from Administrator and configure the ‘Connection Type’ for the
VoIP Ethernet Port accordingly.
• If Connection Type = Static
• By default the connection type is set as Static for all the VoIP Ethernet
Ports.
• Default IP Address of the VoIP Ethernet Port is 192.168.1.116, and
Network Mask is 255.255.255.0, change the IP address and Network
Mask as per your LAN IP Addressing scheme.
• Program the Router’s LAN interface IP Address as the‘Gateway IP
Address’ for the VoIP Ethernet Port.
• Program the DNS Address/Domain Name provided by your Internet Service
Provider.
• If Connection Type = DHCP
• Change the Connection Type to DHCP.
• The VoIP Ethernet Port IP Address, Network Mask and Gateway
Address will be provided by dynamically by the DHCP server on your
LAN. You have to set the DNS address only.
• If DHCP server provides DNS address, set the ‘DNS Connection Type’ to
‘Auto’.
• If DHCP server does not provide DNS address, program the DNS server
address/DNS Name as provided by your Internet Service Provider.
• If Connection Type = PPPoE
• Change the Connection Type to PPPoE.
• The PPPoE server will automatically assign the VoIP Ethernet Port IP
Address, Network Mask and Gateway Address.
• Program the PPPoE User name, Password and PPPoE Service Name
as provided by the Internet Service Provider. Program PPPoE Service
Name only if provided by the Service Provider, else keep this field blank.
To Next Page
Loading...
Need help?
General
