Matrix R1x - ECB (Electronic Brake) Replacement

7.20 ECB (ELECTRONIC BRAKE) REPLACEMENT
CHAPTER 7: PART REPLACEMENT GUIDE
1) Remove the front shrouds as outlined in Section 7.18.
2) Remove the 4 screws holding the ECB and the ECB mounting bracket to the frame (Figure A).
3) Remove the ECB and the ECB mounting bracket from the bike frame (Figure B).
4) Disconnect the ECB wire harness (Figure C).
5) Remove the idler assembly from the ECB (Figure D).
6) Remove the 6 screws going through the ECB mounting bracket into the ECB on both sides (Figures E & F).
7) Once the screws are removed, lift the ECB away from the ECB mounting bracket.
8) Reverse Steps 1-7 to install a new ECB.
9) Test the bike for function as outlined in Section 7.24.
FIGURE A
FIGURE B
47