Matrix R1x - Drive Axle Set Replacement

CHAPTER 7: PART REPLACEMENT GUIDE
7.21 DRIVE AXLE SET REPLACEMENT
1) Remove the front shrouds as outlined in Section 7.18.
2) Remove the idler tension screw (Figure A).
3) Unhook the spring from the idler and remove the spring and 9 hole plate.
4) Rotate the idler so that the tension on the belt is loosened (Figure B).
5) Remove the belt (Figure C).
6) Remove the clip holding the drive axle set into the frame with a snap ring pliers (Figure D).
7) Use a hammer to push the drive axle set to the right side of the frame and off the unit (Figures E & F). NOTE: A piece of wood or other material should
be used between the hammer and drive axle to prevent damage to the drive axle threads.
8) Reverse Steps 1-7 to install a new drive axle set.
9) Test the bike as outlined in Section 7.24.
FIGURE A
FIGURE B
49