Matrox Imaging software 13
Matrox Capture
Assistant
Matrox Capture Assistant is a utility that allows you to rapidly test and evaluate
the performance of virtually any GenICam-compliant device using MIL. GigE
Vision and USB3 Vision devices are currently supported. It can also be used to
configure Host controller settings (such as network adapters) and Matrox-specific
configuration.
Matrox Capture
Works
Matrox Capture Works is a utility that allows you to rapidly evaluate the
performance and functionality of virtually any GigE Vision-compliant camera or
3D sensor (or other device). Matrox Capture Works will list all detected GigE
Vision-compliant devices connected to your computer. It can start or stop
capturing images, display acquired images, save the last grabbed image, send a
software trigger, as well as browse and control the selected device's features. You
can view network adapter information (such as, the IP address, packet size,
inter-packet delay), view and change device information (such as, the user-defined
na me of you r devi ce), view a nd cha nge a cquisition properties, and view acquisition
statistics. You can use it to configure the device and network adapter in static IP
mode (or point-to-point connection mode) or DHCP mode (or corporate
network mode). Matrox Capture Works uses the Matrox GigE Vision discovery
service to automatically detect when GigE Vision-compliant devices are added to
or removed from your network. Matrox Capture Works is distributed with MIL
and Matrox Design Assistant; it is also available with MIL-Lite.
To Next Page
Loading...