P/N 03521015 Rev K Page 61
Donning
8. Connect the Helmet Power Cord to
the Battery. Push the Power Cord
Connector into the Battery Receptacle
until the Secure Connection audibly
clicks.
9. Loosen headband Ratchet
Knob (counterclockwise).
10. Hold Helmet in one hand and pull Cuff
down with other hand. Place chin inside
cuff and pull helmet down onto head.
11. Secure Helmet by tightening Ratchet Knob as tight as
comfortably possible, while ensuring stability. The front
headband should sit within ½ inch of eyebrows for good
visualization of the Safety LEDs.
12. Pull back of shroud up, over, and down behind helmet.
Slide ngers between face and cuff on both sides from
chin to temples to ensure a slight Cuff-to-Face tension.*
WARNING
* If there is a lack of tension, switch to 2260-05SM,
and repeat beginning with step 3.
13. Secure shroud by pulling ties around the waist and tying in
the front. Pull neck ties around to the front and tie securely.
Leaving about a ½ inch gap between neck and Shroud.
14. Optionally, tuck Shroud inside body cover.
Dofng
Reverse steps 8 thru 14 to doff Helmet and remove Shroud.
After disconnecting the Battery from the Helmet, connect it to the Charger (refer to page 38, 12.1 Routine Infection Control use
in med/surg and ED areas, and page 51, 17. Instructions For Use: Charger, for details.
To Next Page
Loading...