P/N 03521015 Rev K Page 73
9. Ensure the DLC Cuff Flappers are out against
the temples by inserting ngers between face
and Cuff and gently pulling Cuff and Flapper
out and then back to temple (both sides).
10.Ensure slight tension is felt continuously
while sliding the index or rst nger
between cuff and face all along the chin
up to the temples, from right to left side
of face.
11.Holding the Helmet securely on
head, grasp back bottom of Hood
Skirt and pull up, over, and down
below Helmet in back.
12.Continuing process of 11, pull Hood
all the way down so that Hood Filter
(blue) is fully down on Helmet.
CAUTION
If conditions in 9.
and 10. are not achieved,
switch to the other size
Hood before proceeding.
16. Ensure Hood Skirt is fully down on
all sides.
Secure Neck ties to within about
1/2 inch of neck.
Secure body ties around waist
area.
14. Initiate donning of Heavy Loading
Filter (HLF) by tucking back bottom
up under back bottom of Helmet
13.Ensure all Filter (blue) wrinkles
above front of Lens are re-
moved by holding shroud
in front below lens and in back
below lter and pulling down rmly.
15. Complete donning of HLF by pull-
ing down rear-to-front and securing
front bottom on Hood front velcro
strips (both sides in front).
To Next Page
Loading...