Maxent 50" User Manual

62
TV Functions
62
EN
Channel Lock
Setting Channel Lock
Set channel lock to block a TV channel from viewing.
Use keys to select CHANNEL LOCK
from TV options and press
to enter
CHANNEL LOCK settings.
A window will now prompt the user to enter a
PASSCODE using the remote control. If the
default system PASSCODE has not been
changed, enter 0000 (this is the initial default
from factory).
As each numeric digit is entered, a small “X”
fills each slot. If the code entered is incorrect,
an “Error” status is displayed. Simply re-enter
the passcode again. After setting the
passcode, the channel is now locked and
viewing is not possible unless the same
passcode is entered.
Notes:
 When entering the 4-digit passcode, please enter the digits slowly. The TV will display “X” in each of
the number slots as it receives the passcode.
 If the wrong passcode is entered three times, the TV will go back to normal viewing state.
EXIT
EXIT
ENTER NEW CODE
ENTER CODE
X
EXIT
EXIT
PASS CODE ENTER
ENTER CODE
CHANNEL LOCK
PRESS OK TO LOCK CH
EXIT
EXIT
SELECT/ADJUST
OK
SET
7-2
Viewing a Locked Channel
To watch a channel that is locked, please follow the steps below:
When a channel is locked and selected for
viewing by the user, the screen will prompt the
user to enter the same PASSCODE that was
used to set the channel lock.
Press to access the OSD menu. Use
keys to select TV from the menu then
press or to enter TV menu..
CHANNEL
LOCK
EXIT
EXIT
PASS CODE ENTER
ENTER CODE

Maxent 50" Specifications

General

Brand	Maxent
Model	50"
Category	Plasma TV
Language	English