Appendix
79
79
EN
You can program the remote control with three different components. Please follow below instruction to
program your VCR, Cable Box/Set-Top Box or DVD Player.
Note:
If your VCR, Cable Box/Set-Top Box or DVD Player does not respond, try other codes for your
brand.
Sometimes a code listed will only include limited functions. Try other codes that may include more
functionalities.
How to Program the Universal Remote Control
Press the , or button on the remote control.
Press and hold the button until the LED LIGHT flashes twice.
Finding the brand of your VCR, Cable Box/Set-Top Box or DVD Player in the component code list
and enter the 5 digital code numbers by using number buttons. If the code is accepted, the LED will
flash after the last digit entered. If the LED does not flash twice, please repeat above steps 1 and 2 until
LED flash twice.
Point the remote control at the VCR, Cable Box/Set-Top Box or DVD Player then presses the button.
The component should be turn on by remote control.
Four Easy Steps for Programming
To Next Page
Loading...
Need help?
General
