68
Advanced
68
EN
Use to select settings and press
keys to confirm selection.
Press the on remote control or MENU key
on the front panel or remote control. Use
to select ADVANCED and press
or keys to enter ADVANCED menu.
Adjusting Advanced Settings
Use to change the setting. As you
change the setting, changes in the picture are
immediately reflected in the video picture. After
achieving the desired setting, press to
return to previous menu or press to exit
menu.
Using OSD MenuU
Various picture adjustments can be set using the Picture Adjustment OSD menu.
Explanation of Various Picture Control Settings
Explanation of each available picture control settings are listed in the table below.
Power Step
Use Power Step to determine whether you would like the display to power-on automaticcally or
remain turned off after power is restored after a “power-outage” incident. Select “1-Step” if you want
the TV to power-on automatically.
Default Aspect
Use to select the default power-on aspect ratio upon power-up. There are three setting to choose
from (1) 16:9, (2) 4:3, (3) Panoramic.
INPUT SKIP
Use to select one input as only one skipped signal, other inputs are vaild. Select NORMAL to keep
all inputs available.
Note:
DEFAULT ASPECT setting will be functional after power has been reset.
PANOROMIC setting from DEFAULT ASPECT is selectable under ANALOG, COMPOSITE and S-
VIDEO modes.
To Next Page
Loading...
Need help?
General
