How to adjust acceleration time on Maxi MWHE20 to increase speed?
If the Maxi Washer motor rotates but the speed does not increase, the acceleration/deceleration time might be too long. Check the data of function code F07, F08, E10, E11 and H54 and change the acceleration/deceleration time to match the load.
How to adjust current limiting for Maxi MWHE20 motor speed?
If the Maxi Washer motor rotates but the speed does not increase, the current limiting operation may not be increasing the output frequency. Check whether current limiting is active or not with Menu#3 'Drive monitoring' and check the current limiting level (F44) using the keypad. Change the level of the current limiting (F44) to an appropriate value. Decrease the value of torque boost (F09), then turn the power off and back on again and check if the speed increases. Check the data of function codes F18, C50, C32, C34, C37 and C39. Change the bias and gain to correct values.
To Next Page
General