12
MAX Arm/Ultra Arm V1
max arm
step-by-step installation
Read and understand this ENTIRE manual BEFORE installation. Check with the local building department prior to installing
this gate operator to comply with local building code requirements. The gate must be installed in a location so that enough
clearance is supplied between the gate and adjacent structures when opening and closing to reduce the risk of entrapment.
Swinging gates should not open into public access areas.
Start by selecting
your model gate
operator for Step 1.
1a
1b
max arm
max ultra arm
Page 12-14
Page 15-17
1a
mount max arm
brackets
release drive rod
Insert key and turn 90°.
Lift key plate.
Drive rod can now
be pulled out.
Drive Rod
1
2
Hardware
(Not Supplied)
Front
Bracket
Bolt or weld to gate.
Bolt or weld to secure.
Rear Bracket Assembly
Sleeve Anchors
(Not Supplied)
Use a nail to remove rear pin.
Rear Pin
Locknut
For PUSH open installation, please order MX115.
The bracket MUST be level and
VERY secure to the plate and wall.
Extreme force will be exerted on this
bracket during gate cycling.
PULL Open Rear Bracket
PUSH Open Rear Bracket
MX115 Bracket
Plate
Weld completely
around the bracket
to secure to the plate.
See page 14 for bracket
positions and dimensions.
To Next Page
Loading...
