Maximum Controls MAX Ultra Arm - Open Ultra Install

24
MAX Arm/Ultra Arm V1
rev 06/14/22
max ultra arm
Limit Cover
Limit Cap
2. Mount actuator arm on REAR bracket ONLY .
1. Clear limits from control box memory. Press and HOLD STOP
and CLOSE buttons together for 5 sec. until
BEEP/ALARM is heard.
Screen will display “LEARNING LIMITS ”.
“BEEP/ALARM”
8. With operator shaft in same position, temporarily
mount FRONT bracket (Clamp or tack weld) to gate in
the OPEN position.
MOTION CONTROL
OPEN STOP CLOSE
LEARNING LIMITS
9. Remove limit cap with 2 screws
and slide limit cover off operator.
pull open ultra arm install
GATE
PULL
OPEN
PUSH
OPEN
Operator MUST be wired to control box. Control box MUST have power.
Rear bracket already secured to gate post
REAR
bracket
secured
OPEN position
5.5”
Extend
Manual Release
Manual Release
Retract
Open
“BEEP/ALARM”
See page 15.
Bolt on FRONT
bracket
Continued on next page
7. Manually move gate to OPEN position.
6. Bolt FRONT bracket to operator.
5. Extend shaft to 5.5” (typical) as shown.
This will be OPEN position of operator.
4. Retract shaft until a BEEP/ALARM
is heard from control box.
3. Manually release actuator arm. See page 15.
Limit Switch Limit Switch
Max = 60.3” (+/-.39“) (1531 mm (+/- 10 mm)
7.35”
186mm
5.07”
128mm
5”
127mm
2
MAX Ultra Arm V1
Limit
Switch
Limit
Switch
PULL OPEN
CLOSE LIMIT
ADJUSTMENT
OPEN LIMIT
ADJUSTMENT
PUSH OPEN
PULL OPEN
OPEN LIMIT
ADJUSTMENT
CLOSE LIMIT
ADJUSTMENT
PUSH OPEN
Max = 60.3” (+/-.39“) (1531 mm (+/- 10 mm)
7.35”
186mm
5.07”
128mm
5”
127mm
2
MAX Ultra Arm V1
Limit
Switch
Limit
Switch
Max = 60.3” (+/-.39“) (1531 mm (+/- 10 mm)
7.35”
186mm
5.07”
128mm
5”
127mm
2
MAX Ultra Arm V1
Limit
Switch
Limit
Switch
PULL OPEN
CLOSE LIMIT
ADJUSTMENT
OPEN LIMIT
ADJUSTMENT
PUSH OPEN
Limit Cover
Limit Cap
Remove limit cap with 2 screws
and slide limit cover off operator.
Adjustment
Screw
Adjustment
Screw
Limit Switch Limit Switch
Limit
Switch
Limit
Switch
1
2
limit switch adjustments
Limit Cover
Limit Cap
Remove limit cap with 2 screws
and slide limit cover off operator.
Adjustment
Screw
Adjustment
Screw
LimitSwitch LimitSwitch
Limit
Switch
Limit
Switch
1
2
limit switch adjustments
PULL OPEN
OPEN LIMIT
ADJUSTMENT
CLOSE LIMIT
ADJUSTMENT
PUSH OPEN
Max = 60.3” (+/-.39“) (1531 mm (+/- 10 mm)
7.35”
186mm
5.07”
128mm
5”
127mm
2
MAX Ultra Arm V1
Limit
Switch
Limit
Switch