Maximum Controls MAX Ultra Arm - EMX IRB-MON (Single Gate)

50
MAX Arm/Ultra Arm V1.2
06-14-22
IMPORTANT: Photocells MUST be powered by
12VDC OUT or they will NOT be MONITORED .
12VDC OUT
Polarity does NOT matter
NCC E COM NO
RX
POWER
INPUT
EARTH
GND
SENSITIVITY
TX
POWER INPUT
TRANSMITTER
BOARD (TX)
ON DIP
1 2 3 4
RECEIVER
BOARD (RX)
Sensitivity Adjustment:
If the photocell does not
respond to an obstruction,
lower the sensitivity by
turning adjustment
counter-clockwise.
Transmitter (TX)
Receiver (RX)
PHOTO CLS NC - Normally Closed
GND - Common
Green
LED
To PHOTO CLS NC
and 12VDC OUT Input
To Control Box
12VDC OUT Input
Transmitter
(TX)
Receiver
(RX)
CLOSING direction Thru-Beam
Gate Closed
TX
RX
Green
LED
NOTE: To meet the UL 325 2018 standard, Type B1
Non-Contact sensor entrapment protection device
MUST be MONITORED by the gate operator.
Installation Steps:
1. Set DIP-switches on receiver.
2. Install jumper on receiver.
3. Wire DSP 12VDC OUT
power to receiver.
4. Wire PHOTO CLS NC
to receiver photocell NC.
Wire DSP Board GND to
receiver photocell COM.
5. Wire 12V DSP
power to transmitter.
6. Align photocells.
7. Adjust sensitivity on receiver.
DIP-switches:
1, 2, 4 are OFF.
Switch 3 is ON
If trouble occurs, try
turning switch 4 OFF.
NOTE: Power must be
cycled when switches
are changed.
IMPORTANT: Photocells MUST
be in alignment or fault will
occur. Green LED will remain
ON receiver when in proper
alignment.
emx irb-mon
OPEN ONLY NC
OPEN ONLY 10K
PHOTO CLS NC
OPEN/CLS NC
GND
12VDC OUT
GND
CLS ONLY 10K
OPEN/CLS 10K
12VDC OUT
UL SENSOR N.C.UL SENSOR 10K
P
NSOR N.C
NSOR N.C
P
SOR N.
P
SOR N
P
SOR N
SOR N
OR N
OR N
OR
UL SEN
N
UL SEN
UL SEN
UL SEN
UL SE
UL SE
UL SE
L SE
L S
Photocell (Thru-Beam) CLOSING Direction
Single Gate Operator
Control Box
DSP Arm Controller
Blue Transmitter (TX) / Red Receiver (RX) Boards