4
MR-2000 - Quick Start Guide
What you need before you can use your MR-2000
LAN Setting:
• Make sure the internet connection is ready and the network settings are available for LAN (ADSL
or Cable Modems are highly recommended).
• To find the MR-2000’s LAN MAC address, please follow this procedure:
Main menu System setup Internet setup View settings MAC Address
Wireless LAN Setting:
• A broadband Internet connection.
• A wireless access point (Wi-Fi) connected to your broadband Internet, preferably via a router.
• If your wireless network is configured to use Wired Equivalent Privacy (WEP) or Wi-Fi Protected
Access (WPA) data encryption then you need to know the WEP or WPA code so you can get the
MR-2000 to communicate with the network.
• If your wireless network is configured for trusted stations you will need to enter the MR-2000’s
MAC address into your wireless access point. To find the MR-2000’s MAC address use menu
items:
Main menu System setup Internet setup View settings MAC Address
• To enter the MAC address into your wireless access point, you must read the instructions
supplied with the wireless access point.
Before you continue, make sure that your wireless access point is powered and connected to your
broadband Internet, or that your LAN cable setting is OK. To get this part of the system working you
must read the instructions supplied with the wireless access point and LAN connecting.
To Next Page
Loading...
Need help?
General
