8
2. Alternatively press SOURCE until <INTERNET RADIO> is shown.
Step 4 – Enter Network
Your MR-2000 will now connect to a Network automatically. After a few seconds, the following will
appear on the screen:
or
If ‘Failed to connect’ message appears, please try the following:
a. Check your router, see if it is working normally or not;
Check your LAN cable. Make sure it is not damaged, and that it is connected correctly.
Connecting to wireless network
Step 1 – Choose Wireless Setting
1. Look up Step 2 “Choose Wired Setting” on page 6 . Press or and select <WIRELESS>, and then
press OK to confirm.
2. Press or and select <DHCP ENABLE>. Press OK to confirm.
Note: 1. you can also simply disconnect LAN cable from the LAN socket before connecting to the network.
2. You can, at any point, press to go back to the previous screen.
Step 2 – Select Your Region
1. Press to go back to <MAIN MENU> subdirectory. Press or and select <INTERNET
RADIO>, and then press OK to confirm.
Alternatively press SOURCE until <INTERNET RADIO> is shown.
To Next Page
Loading...
Need help?
General
