Maxon BMR-44 - Page 20

20
11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
TYP. LH &
RH TUBING
1/8”
STEP 1 - PREPARE VEHICLE IF REQUIRED - Continued
2. Weld Liftgate supports, as shown in
FIGS. 20-1A, -1B, -1C & -1D.
TYP. AT LH &
RH SUPPORTS
TYP. AT LH & RH
SUPPORT GUSSETS.
MOUNT EACH GUSSET
FLUSH WITH OUTER
EDGES OF BODY
FRAME.
60”
RIGHT HAND
(RH) SUPPORT
LEFT HAND (LH)
SUPPORT
36”
Approx.
1/8”
1/8” 2-8
2”
WELDING THE
FLOOR PLATES
FIG. 20-1A
1/8”
WELDING LIFTGATE SUPPORTS
FIG. 20-1B
WELDING THE GUSSETS
FIG. 20-1C
TYP. AT LH & RH
SUPPORTS
1/8”
WELDING THE SUPPORTS
FIG. 20-1D
32”
12”
(MAX. BELOW
BED HEIGHT)
VEHICLE BODY
SIDE RAIL
TYP. LH & RH
FLOOR PLATES
1/8”
1/8”
TYP. AT LH & RH SUPPORT GUS-
SETS. MOUNT EACH GUSSET
FLUSH WITH OUTER EDGES OF
BODY FRAME.
TYP. AT LH & RH
VERTICAL SUPPORTS.
WELD HERE BEFORE
WELDING HORIZONTAL
TUBE & SUPPORT
GUSSETS.
1/8”
1/8”
TYP. AT LH & RH VERTICAL SUP-
PORTS. WELD HERE BEFORE
WELDING HORIZONTAL TUBE &
SUPPORT GUSSETS.
1/8”
1/8”
1/8”
2-8