66
11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
STEP 12 - PRESSURIZE HYDRAULIC SYSTEM
2. To pressurize closing cylinder,
set control box toggle switches
to FOLD for 10-15 seconds as
shown in FIG. 66-2.
To prevent injury and equipment damage, pressurize hydraulic system before
removing lower support fi xtures and operating Liftgate.
WARNING
PRESSURIZING LIFTING CYLINDERS
FIG. 66-1
!
1. To pressurize lifting cylinders,
set control box toggle switch
to UP for 10-15 seconds as
shown in FIG. 66-1.
PRESSURIZING CLOSING CYLINDER
FIG. 66-2
NOTE: Liftgate is shipped with Exxon Univis HVI-13 hydraulic fl uid in the hydraulic
cylinders. This fl uid is suitable for operation in temperature range of -40° F
to +120° F. If necessary, a different brand or higher viscosity hydraulic fl uid
may be used. Refer to the CHANGING HYDRAULIC FLUID procedure in the
BMR Maintenance Manual.
UP
FOLD
NOTE: Before operating liftgate,
read and understand the
operating instructions in
the Operation Manual.
To Next Page
Loading...
