Maxon EPOS4 Disk 60/12 - Prefab Cable Assemblies

Setup
Prefab Cable Assemblies
EPOS4 Disk 60/12 Hardware Reference
CCMC | 2022-05 | rel10685
3-49
3.4 Prefab Cable Assemblies
Best practice
The actual connections you will need to establish depend on the overall configuration of your drive system,
the type of controller, and the type of motor you will be using. Check on
 chapter “4 Wiring” on page 4-63
for the prefab cable assemblies you will actually require in your setup.
Table 3-58 Power Cable High Current
Table 3-59 Power Cable
Power Cable High Current
(710929)
This cable fits
connectors…
X1
X1a
X2
X2a
Type / length
2 x 1.5 mm
2
, non-shielded, grey / 3 m
Wire identifier Characters “+” ¦¦ “−”
Head A
Plug Molex Mini-Fit Plus, 2 poles (0039012025)
Contacts Molex Mini-Fit Plus HCS, AWG16, female crimp terminals (45750)
Head B
Wire end sleeves 1.5 mm
2
Power Cable
(275829)
This cable fits
connectors…
X2
X2a
Type / length
2 x 0.75 mm
2
, non-shielded, grey / 3 m
Wire identifier Characters “+” ¦¦ “−”
Head A
Plug Molex Mini-Fit Jr., 2 poles (39-01-2020)
Contacts Molex Mini-Fit Jr. female crimp terminals (45750)
Head B
Wire end sleeves 0.75 mm
2