Specifications
Standards
IDX 70 User Manual
2-20 mmag | 2022-04 | rel10520
2.6 Standards
The described device has been successfully tested for compliance with the below listed standards.
In practical terms, only the complete system (the fully operational equipment comprising all individual com-
ponents, such as motor, controller, power supply unit, EMC filter, cabling etc.) can undergo an EMC test to
ensure interference-free operation.
EMC compliance
The device’s compliance with the mentioned standards does not imply its compliance within the final, ready
to operate setup. In order to achieve compliance of your operational system, you must perform EMC testing
of the involved equipment as a whole.
Table 2-7 Standards
Electromagnetic compatibility
Generic
IEC/EN 61000-6-2 Immunity for industrial environments
IEC/EN 61000-6-4 Emission standard for industrial environments
Applied
IEC/EN 55032
(CISPR32)
Radio disturbance characteristics / radio interference
IEC/EN 61000-4-2 Electrostatic discharge immunity test 8 kV/6 kV
IEC/EN 61000-4-3
Radiated, radio-frequency, electromagnetic field immunity test
>10 V/m
IEC/EN 61000-4-4 Electrical fast transient/burst immunity test ±2 kV
IEC/EN 61000-4-6
Immunity to conducted disturbances, induced by radio-frequency
fields 10 Vrms
IEC/EN 61000-4-8 Power frequency magnetic field 30 A/m
Others
Environment
DIN/EN 60068-2-27
:2010-02
Environmental testing – Test Ea: Shock / Wheeled vehicle and
heavy industry appliance, table A.1, row 3 (semi-sinusoidal,
500 m/s
2
peak, 11 ms, ±3 shocks each axis, T
amb
298K (25°C))
DIN/EN 60068-2-64
:2010-02
Environmental testing – Test Fh: Vibration, broadband random
and guidance / Equipment in wheeled vehicles (Motor vehicle,
chassis assembly), table A.6, category 1 (sinusoidal,
10…1000 Hz; 33.8 m/s
2
; T
amb
298 K (25 °C))
IEC/EN 60529:
:1991+A1
:2000+A2
:2013
Degrees of protection provided by enclosures (IP Code; Ingress
Protection Code)
Safety UL File Number Unassembled printed circuit board E76251; E207844
To Next Page
Loading...