Need help?Do you have a question about the Maxsine EP100 and is the answer not in the manual?
Diagram showing standard wiring for position control mode.
Disposition charts for servo driver connectors CN1 (36 pins) and CN2 (26 pins).
Details on switch value input interfaces for the servo amplifier, including voltage and current requirements.
Information on switch value output interfaces using Darlington photo-coupler or relay connections.
Explanation of pulse interfaces for command signals, including differential and single input connections.
Description of encoder signal output interfaces using differential drivers or photo-couplers.
Details on the open-collector output for the encoder Z signal and its usage.
Wiring diagram for photoelectric encoder input interfaces of the servomotor.
Description of the front panel display, buttons, and indicator lamps.
Guide to selecting operation modes using the first layer navigation.
Details on accessing and using the monitor mode to view system status and parameters.
Guide on how to select, modify, and confirm parameter values within the system.
Explanation of parameter management operations: write, read, backup, and resume default values.
Instructions for making wiring connections for position control mode using simple wiring.
To Next Page
General