Maytronics BIO - Step 3.2 Put 2 hexagon adaptors into the pulley.; Step 3.3 Put the pulley and the Active Brush gear in their places on both sides of the robot.; Step 3.4 Place the track in its place as shown on both sides of the robot.

BIO Assembly Instructions
Page 4 of 14
Step 3.2
Put 2 hexagon
adaptors into the
pulley.
Step 3.3
Put the pulley and
the Active Brush
gear in their
places on both
sides of the robot.
Step 3.4
Place the track in
its place as shown
on both sides of
the robot.
Step 3.5
Place the side
floats on both
sides of the robot