Mazda 6 - Drive Belt

ENGINE
B15
B
• The upper lower bearing of the connecting rod bearing is made of aluminum alloy.
• There are three kinds of connecting rod bearings depending on the oil clearance.
End Of Sie
DRIVE BELT
A6E222415800T01
Structure
• The drive belt is a serpentine type, which uses a V-ribbed belt to drive the supplemental units. This shortens
the length of engine and makes it easier to service.
• The front drive belt's auto tensioner, in which the coil spring is embedded, has been adopted for the drive belt's
tension. The tensioner pulley automatically maintains the drive belt's tension.
Drive Belt Specification.
( ) is A/C non-equipping vehicle specification.
.
End Of Sie
3 Fracture side
4 Connecting rod bearing cap
5 Connecting rod bearing
Bearing size Color Bearing thickness (mm {in})
Standard Green
1.4961.502
{0.05890.0591}
0.50 {0.02}
Oversize
1.7481.754 {0.06880.0690}
0.25 {0.01}
Oversize
1.6231.629 {0.06390.0641}
ITEM L8 LF L3
Belt length size mm {in}
About 2,255 {88.78}
(About 2,160 {85.04})
About 2,305 {90.75}
(About 2,210 {87.01})
Belt width size mm {in} About 20.5 {0.81}
AME2224N013
1 P/S oil pump pulley
2Drive belt
3 Idler pulley
4 Generator pulley
5 Front drive belt auto tensioner
6 Crankshaft pulley
7 A/C compressor pulley
8 Water pump pulley