53
3.3.5 Changing the road types used in route planning
To recalculate the active route with different road type preferences, do as follows. These
changes can also be made in Settings (page 63).
1. If you are on the Map screen, select
to return to the Navigation menu.
2. In the Navigation menu, select
.
3. Select any of the listed road types to modify the route. If needed, scroll the list for all
road types. You have the following options (their order depends on the selected vehicle
type):
•
- You might need to avoid highways/freeways if you have to drive
slowly or you are towing another vehicle.
•
- Charge roads are pay roads where you can purchase a pass
or vignette to use the road for a longer period of time. They can be enabled or
disabled separately from toll roads.
•
- The navigation system includes toll roads (pay roads where
there is a per-use charge) in the routes by default. If you disable toll roads, the
navigation system plans the best toll-free route.
•
- The navigation system includes ferries in a planned route by
default. However, a map does not necessarily contain information about the
accessibility of temporary ferries. You might also need to pay a fare on ferries.
•
- Setting in which routes with carpool lanes can be created or not
created.
•
- The navigation system excludes unpaved roads by default:
unpaved roads can be in a bad condition and usually you cannot reach the
speed limit on them.
4. The route has already been recalculated. Select
to return to the Map screen. The
orange line now shows the new recommended route.
NAV-6AVUAEA.indb53NAV-6AVUAEA.indb53 2013/07/3110:51:362013/07/3110:51:36
To Next Page
Loading...
Need help?
General
