64
4.2.4 Map settings
You can fi ne-tune the appearance of the Map screen. Adjust the map view to your needs,
choose suitable color themes from the list for both daytime and night use, change the blue
arrow to a 3D car model, show or hide 3D buildings, turn track logging on or off, and manage
Place visibility sets (which Places to show on the map).
The map is always shown on the screen so that you can see the effect when you change a
setting.
Button Description
Switch the map view between a 3D perspective view and a 2D top-down
view.
Adjust the basic zoom and tilt levels to your needs. Three levels are
available.
During route guidance while in 2D mode, the function which zooms in on
approaching intersections turns on/off automatically.
Show or suppress 3D city models, 3D artistic or block representation of
full city building data containing actual building size and position on the
map.
When selected, the map zooms out to show an overview of the
surrounding area if the next route event (maneuver) is far. When you get
close to the event, the normal map view returns.
Select which Places to show on the map while navigating. Too many
Places make the map crowded so it is a good idea too keep as few of
them on the map as possible. For this, you have the possibility to save
different Place visibility sets. You have the following possibilities:
• Select the checkbox to show or hide the Place category.
• Select the name of the Place category to open the list of its
subcategories.
NAV-6AVUAEA.indb64NAV-6AVUAEA.indb64 2013/07/3110:51:372013/07/3110:51:37
To Next Page
Loading...
Need help?
General
