5.1.1 MENU
Within the menu two control buttons, on the right side, are used to move the
cursor *, Select enters the chosen menu point, Exit leaves it.
5.1.2 DIM STANDBY
At this point you can adjust the brightness of the ring around the standby-button when
standby is activated. This setting is sent to all other devices within the MBL SmartLink
chain. If the value has been readjusted, and Exit has been pressed, further Options appear,
Cancel, Discard, and Save. Save keeps the change, Discard rejects it, and you return to
the menu. Cancel brings you back to the screen where you can change the value.
5.1. 3 INFO
Exit brings you back to the menu.
5.1.4 FACTORY DEFAULT
Here you can reset the whole device. All changes to the factory default settings will be
lost. To start the reset procedure, press the Execute button for two seconds.
C31
To Next Page
Loading...
