27
5.2 C11 / C51 MENU NAVIGATION
After switching on the device by pressing the standby button, the standard display is shown.
By turning the volume control knob the volume can be adjusted. The current value is
Below the control buttons (softkeys
displayed.
Mute
pressed another time.
Amp on/o
Menu shows the menu for further options which can be left by pressing Exit.
In- / In+ activates the desired input channel including the inputs of the C31. In case a digital
input of the C31 is selected, no functions of the CD-DAC are available.
5.2.1 MENU
Within the menu two control buttons, and on the right side, are used to move
the cursor *, Select enters the chosen menu point, Exit leaves it.
5.2.2 INPUT SETUP
Use the control buttons and to navigate. The buttons Enable and Disable activate or
deactivate the input channels which shall be shown in the standard display. When the little
square next to the input name shows a tick, the input channel is activated. It is not possible
to deactivate CD1. When the new setting is complete, you leave the screen via Exit, then
another screen shows up. Save saves the new setting, Discard rejects it and Cancel brings
you back to the last shown screen where you can make further alterations.
C11
C51
To Next Page
Loading...
