29
5.2.7 INFO
module. Exit brings you back to the menu.
5.2.8 FACTORY DEFAULT
Here you can reset the whole device. All changes to the factory default settings will be
lost. To start the reset procedure, press the Execute button for two seconds.
5.3 C15 MENU NAVIGATION
RCA
key and XLR beneath the third soft key. Please choose the desired input by pressing the
corresponding soft key. This input is then activated, this can be changed later if necessary.
In normal operating mode the currently selected input or a deactivation Amp is o is
shown in the display.
Amp on/o
Amp is o is being displayed instead of the input. Pressing the soft
Important:
Amp is o mode!
By pressing the soft key In+ you can toggle between the inputs which are activated in the
input setup menu point. Please note that the signal level of XLR high
signal level of XLR. In the default factory setting XLR High is disabled, this can be changed
in the input setup menu point.
By pressing the soft key Menu you enter the menu display. You return to the normal display
by pressing Exit.
C15
C11
C51
To Next Page
Loading...
