30
5.3.1 MENU
You navigate within the menu by pressing the soft key and pressing Select when the
cursor * is next to the de-sired menu point. To leave the menu point press Exit.
5.3.2 INPUT SETUP
Use the right soft key to navigate. The soft key Alter changes the state oft he selected
input. If there is a tick in the little square, the input is activated.
When the new setting is complete, you leave the screen via Exit, then another screen
shows up. Save saves the new setting, Discard rejects it and Cancel brings you back to
the last shown screen where you can make further alterations.
5.3.3 DIM STANDBY
At this point you can adjust the brightness of the ring around the standby-button when
standby is activated. This setting is sent to all other devices within the MBL SmartLink
chain. If the value has been readjusted, and Exit has been pressed, further Options appear,
Cancel, Discard and Save. Save keeps the change, Discard rejects it, and you return to the
menu. Cancel brings you back to the screen where you can change the value.
5.3.4 INFO
back to the menu.
5.3.5 FACTORY DEFAULT
the reset procedure, press the “Execute” button for two seconds.
C15
To Next Page
Loading...
