16
[7] Test folding
Press the “TEST” key, and one sheet will be folded.
(The counter display will remain to display [0].
Check the folding result with the folded paper.
Hint!
<Causes of folding misalignment>
▪ Stains on the roller
▪ The paper guide is set askew, or it is not in close contact with the paper.
▪ The paper feed table is set askew.
▪ The paper is cut at a slant.
<To correct folding misalignment>
→ Refer to “5 - 6 Adjustment” on pages 23 to 27.
[8] Continuous folding
Press the “START/STOP” key, and the paper feed
table will move up and the machine will
continuously fold the paper.
When the “START/STOP” key is pressed while the
machine is in operation, the machine will stop the
operation, but the addition on the counter will
continue.
If you wish to fold only the number of sheets
desired, refer to “5-9-2 Subtraction Mode” on page
34.
If paper is not ejected smoothly, refer to “5-6-3
Adjustment of Paper Ejection Roller Position” on
page 27.
To Next Page
Loading...
Need help?
General
