McAfee NS Series - Unpack the Sensor

• Set of rack mounting rails
• Printed Quick Start Guide
• Serial Console Cable (DB9-DB9)
• QSFP28 Direct Attach Copper (DAC) cable
Unpack the Sensor
1
Open the crate.
2
Remove the rst accessory box.
3
Verify you have received all parts.
These parts are listed on the packing list and in the section, Contents of the box.
4
Remove the Sensor.
5
Place the Sensor box as close to the installation site as possible.
6
Position the box with the text upright.
7
Open the top aps of the box.
8
Remove the accessory box within the Sensor box.
9
Verify you have received all parts.
These parts are listed on the packing list and in the section, Contents of the box.
10
Remove the Slide Rail Kit.
11
Pull out the packing material surrounding the Sensor.
12
Remove the Sensor from the antistatic bag.
13
Save the box and packing materials for later use in case you need to move or ship the Sensor.
Before you install
Unpack the Sensor
3
McAfee Network Security Platform
13