McAfee NS Series - Install the slide rails and rack mount the Sensor

Install the slide rails and rack mount the Sensor
Follow this procedure to assemble the slide rails and position the Sensor on it.
Task
1
Disassemble inner slide rail members from cabinet sections.
a
Pull inner member out until it comes to a lock position.
b
Depress the QD latch to fully disconnect inner members.
2
Mount inner members to the chassis unit.
a
Place each inner member on both sides of the chassis unit. Position the bottom mounting holes of the
inner member with matching mounting holes on chassis unit.
b
Use screws to secure inner members in place. Apply to both sides of chassis unit.
3
Mount slide cabinet sections to the rack.
a
Install the front end of each slide cabinet section to rack using the slide tool-less features. The tool-less
latch rotates when the bracket is pressed up against the rack rails.
b
Align, adjust, and attach the rear brackets to the rack rail.
4
Setting up the Sensor
Install the slide rails and rack mount the Sensor
16
McAfee Network Security Platform