McCulloch Li 40T - Cutting Line Replacement

13
English -
MAINTENANCE
• Install the new spool so that the cutting line and
slot align with the eyelet in the sides of the cover.
Thread the cutting line into the eyelet.
• Pull the cutting line extending from the cover so the
cutting line releases from the slot in the spool.
• Reinstall the spool cover by depressing tabs into
slots and pushing down until spool cover clicks into
place.
Cutting line replacement
• Remove the battery pack.
• Remove the spool from the cutting head.
NOTE: Remove any old cutting line remaining on the
spool.
• Cut a piece of cutting line approximately 3m long.
m
3
• Bend the line at the midpoint and hook the loop into
the slot in the center rim of the spool. Ensure line
snaps into position in the slot.
Slot
• Wind the line evenly and firmly in a clockwise
direction. Once completed, put the line in the slot
so it does not unwind.
Slot
Slot
• Do not wind the line beyond the edge of the spool.