EasyManuals Logo

McCulloch Li 40T User Manual

McCulloch Li 40T
392 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
15
English -
TROUBLESHOOTING
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
String will not advance when
using the bump-feed head.
String is welded to itself. Replace string.
Not enough string on spool.
Install more string. Refer to string
replacement earlier in this manual.
String is worn too short. Pull string while pressing line release button.
String is tangled on spool.
Remove string from spool and rewind. Refer
to string replacement earlier in this manual.
Grass wraps around shaft
housing and string head.
Cutting tall grass at ground level
Cut tall grass from the top down to prevent
wrapping.
Motor fails to start when switch
trigger is depressed.
Battery is not secure.
To secure the battery pack, make sure the
latch on bottom of the battery pack snaps into
place.
Battery is not charged.
Charge the battery pack according to the
instructions included with your model.
Shaft not connected completely
Make sure lower shaft is fully seated in shaft
coupler on upper shaft and secure shaft
coupler.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the McCulloch Li 40T and is the answer not in the manual?

McCulloch Li 40T Specifications

General IconGeneral
Power sourceBattery
Battery voltage40 V
Battery capacity2 Ah
Battery charger includedYes
Cutting width350 mm
Product colorBlack, Yellow
Rotational speed5500 RPM
Cutting diameter (max)- mm
Weight and Dimensions IconWeight and Dimensions
Depth180 mm
Width120 mm
Length1680 mm
Weight5780 g
Package depth970 mm
Package width265 mm
Package height165 mm
Package weight5540 g

Related product manuals