19
C2800
Lip Sync Delay
When the Lip Sync Mode is set to Manual, and
when the HDMI Input is selected, the Trim menu
will allow the HDMI Audio Lip Sync Delay to be
adjusted from 0 to 150ms in 10ms intervals.
HXD Mode
When headphones are connected to the C2800
Front Panel Jack, an additional TRIM function
becomes available. McIntosh’s HXD brings the
acoustical depth and spatiality of music normally
heard with loudspeakers, to your headphones.
Note: The Headphone Output is optimized for impedances
ranging from 100 to 600 ohms.
Trim Functions Menu (continued) Tone Control
With the Tone Controls are On, the Treble and Bass
Trim Settings may be adjusted for the currently
selected input source. The TONE LED indicator
will be illuminated. When the Tone Controls are
Off, the previous settings for Treble and Bass are
bypassed from the signal path.
Note: the audio signal present at the SEND FIXED OUT Jacks is
unaffected by the TONE settings.
Bass
The intensity of the low frequencies in the music
can be increased or decreased by using the Trim
Select and Trim Adjust controls.
Treble
The intensity of the high frequencies in the music
can be increased or decreased by using the Trim
Select and Trim Adjust Control.
20 20k50 100 200 500 1k 2k 5k 10k
0
+6
-6
+12
-12
dB
Hz
Network Information Menu
The Network Information Menu lists information
about network connection. Press the VOLUME
Knob to open the Network Information Menu.
Navigate between settings using the INPUT Knob.
The chart below details all of the available settings.
Settings Options
Connection Type Displays Connection Type
IP Address Displays IP Address
Ethernet MAC Address Displays Ethernet MAC Address
Wi-Fi MAC Address Displays Wi-Fi MAC Address
McIntosh Connect App
Press and hold the VOLUME Knob to put the
C2800 into Network Setup Mode. The NETwork
Status LED will blink–indicating that network
settings can be congured from the McIntosh
Connect App.
Note: The C2800 will exit Network Setup Mode if put into
Standby.
To Next Page
Loading...
Need help?
General
