21
The MA5200 incorporates an Auto Off Feature, which
automatically places the preamplifier into the Power
Saving Standby/Off Mode. This occurs approximately
30 minutes after there has been an absence of audible
audio signals on the selected input (on either chan-
QHORUXVHUDFWLYLW\LQFOXGHVFKDQJHVWRDQ\RIWKH
Operation Functions such as source selection, volume
DGMXVWPHQWHWF,ILWLVGHVLUDEOHWRGLVDEOHWKH$XWR
Off Feature perform the following steps:
1. Press and hold the INPUT CONTROL until the
Front Panel Display indicates the Setup Mode is
active. Then rotate the INPUT CONTROL until
the Setup Menu item “SETUP: POWER MODE,
Auto Off: Enabled” appears on the Front Panel
Display. Refer to figure 19.
2. Rotate the VOLUME Control until “SETUP:
POWER MODE, Auto Off: Disabled” appears on
the Front Panel Display. Refer to figure 20.
3. To exit from the Setup Mode, press the INPUT
CONTROL and the Front Panel Display will revert
back to its normal display.
Note: To reset the Remote Control to normal
codes perform steps A and B then enter
3, 2, 4, 2 and 8 for step C.
5. Press the VOLUME UP/DOWN Push-button on
the Remote Control to verify proper operation.
Power Mode
Figure 19
SETUP: POWER MODE
Auto Off: Enabled
Figure 20
SETUP: POWER MODE
Auto Off: Disabled
Setup, con’t
To Next Page
Loading...
Need help?
General
