www.marketdirect.com.au Ph: 1300 494 494
57
12 MONTHS / 10,000KM SERVICE CHECKED
Chassis and Suspension
Hitch
• Inspect for damage and lubricate. Check bolt Torque to 90Nm
Jockey Wheel • Inspect for condition and operation
Breakaway • Check for correct operation.
• Inspect lanyard and clip
Drawbar • Inspect wiring grommets and general condition
Suspension • Torque bolts to 190Nm
• Grease bushes and check for play.
• Check torque on suspension hanger bolts (190nm)
• Check retaining chain shackles tight.
• Inspect shock absorber for condition.
• Inspect shock absorber bushes
Brakes • Inspect and adjust. Check lining thickness and drum wear
Wheel bearings
• Replace bearings, seals and lubricate. Check stub axle condition and
wear. Replace split pin.
Wheel Nuts
• Inspect condition and torque to 125Nm (12mm studs)
(140Nm 14mm studs alloy rims) (200Nm 14mm studs steel rims)
Tyres • Inspect for abnormal wear, damage, and pressure.
• Check manufacturing date less than 5 years.
• Check sidewalls for perishing and damage.
12 volt electrical
Lights • Check all trailer lights are functioning.
• Check plug pins have gap.
• Check for corrosion
Battery • Check terminals and voltage at full charge.
• Check batteries are secure in cradles
Charging • Check battery charger settings are correct.
• Check DC to DC charger settings are correct
Solar Panels • Check panels are free of damage.
• Inspect sealants on cable penetrations and junction boxes
Cables • Inspect cables under body for damage to conduits.
• Inspect cable glands and sealants on penetrations through oor
240 volt Electrical
RCD Unit • Check operation of RCD via test button
Mains Input • Inspect mains input plug and cover are free of damage
Earthing • Carry out resistance check
Caravan Body
Hatches & Doors • Check and lubricate locks
Seals M.D.C
G.roup
• Check condition and correct latch/lock adjustment for correct 30-50%
compression