MDC XT12HR 2021 - Gas Appliance Safety; Removing the Flue Cover; Isolating Appliances

12
Gas Appliance Safety
• Gas appliances are certified and have a flame safeguard feature to stop gas flow in the event of the
flame going out. Never interfere with this function or replace appliances with a non-certified type.
• Slide-out kitchens with cookers should only be operated with an annex fully erected. Failing to do
so
may affect the safety and operation of the gas appliance.
• Slide-out kitchens with cookers must only be used with a flexible connecting hose that is
disconnected from the gas bayonet fitting when in its stored position. Under no circumstances
permanently connect this appliance.
• Only approved and suitable gas appliances with flame safeguard systems shall be connected to the
gas bayonet (if fitted).
Removing the Flue Cover
Cauon! To use your inbuilt Truma hot water system, the external flue covers must be removed prior to starng the
unit.
First, open the flue dust cover shown.
R
emove lockable cover Remove plasc cover Ready for use
Caution
To use your inbuilt Tr u m a hot water system, the external flue covers
must be removed prior to starng the unit.
Ventilation and Flues
• Check all permanent ventilators, flues (if applicable) and vents to ensure they are clear, open and
unrestricted.
• Any supplied or 3rd party vent cover(s) (e.g. low level door vent) should only be used for covering the
vents during storage between use with all LP gas system valves closed. All vents (e.g. low level door vent)
shall be uncovered at all times the Caravan is in use.
Isolang Appliances
Internal gas appliances have an isolaon valve fied in the gas line. During travel these should be turned to the off
posion where praccal and always turn the valve on the acve gas bole off when towing or refuelling.