Page 1-5
1532ES / 1932ES Operator’s Manual May 2005
♦ Use of scissor lift as a crane to lift oversized or hanging loads is prohibited.
♦ Always check route and areas are clear before driving, lifting or lowering.
♦ It is recommended to avoid sudden braking or steering. Go slowly and leave
more maneuvering room during cold weather operation.
Fall Protection Notice
The Guardrail System around the perimeter of the platform is the fall protection sys-
tem for self-propelled elevating work platforms per the American National Standards
Institute ANSI/SIA A92.6 Standard. It is prohibited to use an Aerial Work Platform
manufactured by MEC with any portion, or all, of the guardrails removed.
Lanyard anchorage points on this type of equipment are not required to conform to the
applicable ANSI/SIA Standard.
THE IMPROPER USE OF FALL ARREST SYSTEMS MAY
CAUSE MACHINE TO TIP RESULTING IN SERIOUS INJURY
OR DEATH.
However, if anchorage points for lanyard attachments are required by site authorities or
other regulations, the anchorage points on all equipment manufactured by MEC are
recommended to be used for work positioning restraints of personnel only. Lanyard
lengths are to be determined by operator/owner to restrict the operator to the confines
within the Guardrail System.
To Next Page
Loading...
