Page 2-12
May 2005 1532ES / 1932ES Operator’s Manual
BRAKING
ACTIVATION OF THE PLATFORM “EMERGENCY STOP”
BUTTON WILL APPLY BRAKES IMMEDIATELY. THIS MAY
CAUSE UNEXPECTED PLATFORM MOVEMENT AS THE
MACHINE COMES TO A SUDDEN STOP. BRACE YOURSELF
AND SECURE OBJECTS ON THE PLATFORM DURING
OPERATION OF MACHINE.
NOTE: For parking, the brake is automatically applied when the forward/reverse
drive controller is positioned in the center (neutral) position.
ELEVATING THE PLATFORM
USING PLATFORM CONTROLS
To elevate the platform, activate mode selector switch in the “Lift” position. Depressing the
Enable bar and moving controller handle “towards” the operator will elevate the platform.
Rate of lift is proportional and is dependent on the movement of the controller handle.
USING BASE CONTROLS
With selector switch in the “Base” position, press and hold the Lift/ Lower toggle switch on
the base control panel in the “Up” position until the desired height is reached or until the
platform reaches maximum height.
LOWERING THE PLATFORM
USING PLATFORM CONTROLS
To lower the platform, activate mode selector switch to the “Lift” position. Depressing the
Enable bar and moving the controller handle “away” from the operator will lower the plat-
form. Rate of descent is fixed - platform lowers at same rate regardless of handle position.
USING BASE CONTROLS
With selector switch in the “Base” position, press and hold the Lift/ Lower toggle switch in
the “Down” position until the desired platform height is reached or until the platform reaches
the stowed position.
To Next Page
Loading...
