Page 2-14
May 2005 1532ES / 1932ES Operator’s Manual
SHUTDOWN PROCEDURE
♦ When finished with the machine, place the platform in the stowed position.
♦ Park the machine on a level surface.
♦ Carefully exit the platform using a constant three (3) point dismount/grip.
♦ Place selector switch at base control panel in the “Off” position.
NOTE: Leaving the selector switch in the base or platform position for an extended
time will drain the battery. Always put the selector switch in “Off” position
when leaving the machine at the end of the work day.
♦ Put a padlock on the battery disconnect switch to prevent unauthorized operation.
MOVING THE MACHINE
Machine can be winched or moved short distances in case of power failure at speeds not to
exceed 5 MPH (8.05 kph).
TOWING/ WINCHING THE MACHINE
Your machine is equipped with a brake release.
PRIOR TO MANUALLY RELEASING BRAKES, INSURE
WHEELS ARE CHOCKED TO PREVENT MACHINE FROM
MOVING.
Release Brakes Before Towing:
♦ Push in the manual brake release valve located on the main manifold.
♦ Using the hand pump in the battery compartment, pump valve until pressure is built.
♦ Machine is now ready for towing.
To Next Page
Loading...
